It is limited to Bafang brand throttle and indicator and brake lever. Accessories from other brands are not compatible. This controller is only suitable for BAFANG-G060 750w fat motor. It can be used with BAFANG display, throttle and brake lever. It is limited to BAFANG brand throttle and display and brake lever.This controller has the functions of driving lights and brake lights, and it has an impressive brake light effect when braking while driving. Color: silver and black, as picture. Excellent outdoor design: IP65 Waterproof capacity. Compatible Models:- BBS01, BBS02, forBBSHD, M400, M500, M600, M620. This display works with all Electric bikes with a Bafang motor and a UART Connector. Allowable Power:- 36v, 48v, 52v. Connector:- Green Round Waterproof UART (5 Pin female socket). Length: 66.5mm, Width: 49.3mm, Depth: 46.9mm. Serial communication interface to facilitate maintenance service. Four stalls of power assist control: ECO-TOUR-SPORT-TURBO. Headlight indicator: Headlight on / off status indication (need information from the controller). Mileage display: Subtotal mileage (TRIP), total mileage (ODO). Riding time: (TRIP TIME) display.
Size: inner ring 22.2cm outer ring: 47cm. Color: Black (As Pictures Show). Pin A-Male Green 5 Pins Display(G5.2). Pin B-Female Yellow 3 Pins Left Brake. Pin C-Female Yellow 3 Pins Right Brake.Pin D-MaleYellow 3 Pins Throttle. Pin E-Male 8 Pins(M8.4)Mid Motor Main Cable. Specifications for motor controller 750W. Type: Motor Controller (It is limited to BAFANG brand throttle and display and brake lever).
Scope of application: 750Wkit and bafang motor. Length of right front oil pipe: 100CM Right front net weight: 340g Left rear oil pipe length: 165CM Rear left net weight 360g 3-core waterproof cable female end broken wire length: 48CM +/- 0.5CM Packing size: 23x13x16CM Package weight: 0.9KG. Four-piston power-off oil brake: 1 set (front brake: 100CM, rear brake: 165cm).Dual Hall assist sensorx 1. Throttle: x1 (choose oneof 130X and 140X). The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. Please allow slight manual measurement deviation for the data.
Some customers bought other brands of booster sensors to connect with this controller because different brands cannot be used normally, resulting in damage to the controller. If you use other brands of power assist sensors, please refer to the linesequence arrangement in detail. The PAS wiring diagram of this controller has been released, please do not use other brands of products with our company's controller, which can easily cause damage to the circuit. Also, the each additional item means. The the same color and size.
Transit time may be a little delayed because of the. If you have any questions.